Heritage Patios H1P251004321012 Manuel du propriétaire télécharger pdf (Page 11)

Need help with installation? Visit HeritagePatios.com/DIY

STEP 4: PREPARE POST

Components Needed

 Front fascia

 Bottom post bracket

 Square post

Tools Recommended

A minimum of ½” per foot slope recommended for proper water drainage

FIRST: Slide bottom post bracket up into

post, drill 3/8” diameter holes through both

post and bottom bracket. Use two 3/8” x 3-

1/2” bolt and but to fasten. Determine

length of post by measuring the distance

from patio floor to the bottom of hanging

channel, then deduct 4” for the back leg of

fascia and also deduct min. ½” per foot slope

of panel length.

SECOND: Now fasten the square post to

the top post connector previously installed

to fascia. Drill two 3/8” diameter holes

through both post and post connector. Use

two 3/8” x 3-1/2” bolt & nuts to fasten. Front

fascia must be “level” from end to end.

THIRD: Raise the assembly into position and

temporarily stabilize the front fascia & post

in upright position by tying each end post to

each ladder with a rope or cord. DO NOT

attach post to patio surface until proceeding

to STEP #7 and ensuring first roof panel

insert is “squared” to front fascia and post

assembly.

NOTE: Uneven patio surface will require varying lengths of each post across uneven surface.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Pas de commentaire

Heritage Patios H1P251004321012 Manuel du propriétaire Page 11